Main Discussion Area > Around the Campfire

KITH

<< < (21/60) > >>

D. Tiller:
Just got both obsidian blades finished. They're in the tear drop fashion (Dont remember the exact name. laurel leaf?) and made out of Glass Buttes obsidian, one from the pumpkin and the other from the Red stuff. No I will not reveal where I got the red stuff. IT'S MINE!!!! MINE! MINE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!  ;D ;D ;D

sailordad:
well ihavent had any luck finding bras rod for pins for the handle of my knife,so i decided to go with glue.

i have one question though, what kind of 2 part epoxy should i use,any ideas?

                    thanks
                                                     tim

DanaM:
Tim for brass rod go to a auto parts store or welding supplier and get 1/8 inch brazing rod, you have to clean the flux off and I always use glue even with the pins.
I prefer devcon 5 minute epoxy.

madcrow:
Check tractor supply and welding supplies, hardware stores.  Some sell the rods without the flux in 3 ft. sections.  I use  the Devcon 2 ton epoxy.  It works great.  Pm me your address and I will send you some brass and stainless steel rods.  I have several hundred, so I am sure I can spare a few.

mullet:
  Home Depot and Truevalue have it in 3' sections. You can go to Hobby stores and get the tubing and star rod to make Mosaic pins.

Navigation

[0] Message Index

[#] Next page

[*] Previous page