Main Discussion Area > Arrows

split arrows

(1/2) > >>

possum:
OK, I've been wondering.  I have no good bow wood on my property that would yield a bow length piece or even billets but... I have several poplar trees that could come down that are VERY straight.  I know it pretty much tinks for bows but everyone says make arrows.  GREAT!!  how?  I don't have a planer or even a plane.  I do have a bandsaw and a 12" disk sander.  I think I can figure out how to split it into small pieces with a big knife and a hammer but what would be an effective way of squaring it or even just dowelling it without too much waste?  And should I split it while dry or let it dry awhile?  Thanks,

possum

Pat B:
Possum, Reduce the poplar by splitting it down to 1/2"x1/2" and make them long(36" if possible). With a thumb plane($10 from ACE hardware, lowes. Home Depot, etc.), remove the four corners down the whole billet. This will make 8 corners...remove them and have 16(and getting close to round) You keep this up until the "shaft" is round and the diameter you want.
   You can also saw out billets. Try to keep the grain parallel with the shaft.    Pat

DanaM:
#10 for a thumb plane now, remember when they were only$5 :o

possum Iuse my band saw to rip 3/8"x3/8" squares and then like Pat said use the thumb plane to round it, I made a device to help align and hold the blanks,
router a V groove in a board and put a small nail in one end for a stop. works pretty good.
I also made a die to run the blanks thru with a drill, a steel plate with holes drilled in it descending in size by 1/32" each time. Then use a bigger bit to kind of taper each hole, stop at least one size bigger than what you want and sand to size.

possum:
This is all after it dries?  right?

Hillbilly:
I do like Pat said- I split the poplar rounds into 1/2" thick "boards" just like making shingles. I let them dry out, then true two sides with drawknife or belt sander and rip them into 3/8"x3/8" squares on the table saw and round them with a thumb plane (only $7.99 at our Lowe's  ;D ) and sandpaper. I have split them out, too-it works but you get more waste than sawing. A froe is a big help if you're splitting them. I've made good shafts like this from poplar, pine, and ash. The main thing is to choose wood with really straight grain and don't violate it. Sometimes a chunk of tree is straight on the outside, but the grain wanders and twists inside, especially close to the center of the log.

Navigation

[0] Message Index

[#] Next page