Primitive Archer
Main Discussion Area => Bows => Topic started by: Aaron H on October 25, 2014, 05:45:07 pm
-
I am just finishing up on an osage static recurve. Tillering is 90% complete. Problem is, that the curves don't exactly match as well as I would like them to. If I set the bow on my bench at brace height, one limb curves about 3/4" more than the other. They are not radical curves but not real gentle ones either. I am considering using some shortening and some dry heat to induce a little more curve into the 'weaker' limb. I think it would actually help even out my tiller, as that limb is pulling a tiny bit further than the limb with the heavier curve in it. What do you think?
-
You could try to cook it in the same form you used before.
Uneven hooks drive my ocd brain nuts, and there's a few bows in the corner as a result ;)
-
Yea, my wife said "I don't see any difference". Well I certainly do
-
Next time, try to make your tips the exact same thickness when you heat in your recurves. I think it plays a big part in this
-
+1 wizardgoat
-
Well I was a little worried it might screw up my tiller, but I used some Crisco and some dry heat and it bent around just fine. Tiller barely changed at all. The thickness of both limbs were the same before I bent them (I like to check everything with my dial calipers), and I couldn't use the same caul because I had already added tip overlays. Thanks anyways guys.