Primitive Archer
Main Discussion Area => Arrows => Topic started by: swimbill on February 05, 2009, 01:41:06 pm
-
Hi I just received a lot of cedar shafts, some are very good others not so straight. What is the best method for straightening out cedar shafts.
-
sometimes you can just hand straighten..bend where it needs and hold for a second...might have to heat them a tad ..just don't overheat...gut
-
What Gut said!
-
One of those little hooks like you screw into the wall works pretty good, just screw it into a wooden handle, put it over the shaft, and rub it on the outside of the bend while you'r putting a little pressure on it.
-
I made a tool like Hillbilly suggested and here is a pic of how it is used.
(http://i5.photobucket.com/albums/y199/PatBNC/arrowmakingtools003.jpg)
-
Hi, POC is usually easy to straighten and hand straightening works best for me. For those few shafts that require more I like the 'ACE' brand compression straightener. 3R has them. The "'ACE' works well on more difficult woods like ash as well. Ron
-
Pat B. : ( Not to interrupt this thread) but will those kind of straightening tools with work with cane and bamboo without heat?
-
You will need heat to get them straight initally but this tool will help if they get a little out of straightness between the nodes.
-
I use the Shaft Tamer from 3Rivers and a solid flat surface (counter top).
-
PatB, is that bamboo in your pic with the tool?
-
Yes, Pup! It is a native bamboo(Arundaneria appalachiana) aka hill cane. Pat