Primitive Archer
Main Discussion Area => Flintknapping => Topic started by: Blacktail on March 25, 2009, 02:12:43 pm
-
This is my first attempt at a Thebes point. It is four inches long and is almost two inches wide. It is Obsidiain. Again, any advice would be helpful. Thanks, JOhn
(http://img.photobucket.com/albums/v231/longarrow/DSC_0060.jpg)
(http://img.photobucket.com/albums/v231/longarrow/DSC_0056.jpg)
-
my wife went ahead and posted these photos for me while i was at work (bless her heart)....but,what i wanted to do on this one was to show more of the notching...i did notching differantly....i used a copper notcher that was shaped like a screwdiver and a small antler billet and punched the notches in....for some this might be nothing new but for me it was and i had a blast learning it...and i think i can do deeper notching using a punch....thanks john
-
you need to stop posting such pretty points on here!!! My points look like they were made by dropping a boulder of flint off an 87 story building!
-
There ain't a thing wrong with that one , John. Good looking piece of Obsidean, too.
-
Fancy meeting you here.
Nice blade!
PD
-
i think you guys are just being to nice to me.SO WHAT DID I DO WRONG.LOL,LOL..john
-
Looks fine to me.
-
The only thing you did WRONG was post such a pretty point in a section where we're usually makin' gravel!
-
sweet point very nice blaacktail. My points always end up alot smaller than that. They start out wanting to be that size. must be the creator. ;)