Primitive Archer
Main Discussion Area => Bows => Topic started by: aruge on March 18, 2010, 05:57:36 pm
-
Hi, long time. I've been working on a shagbark hickory selfbow. I've got it tillered, the belly and sides stained and sealed with a few coats of truoil. The back has a coat of spar eurethane from when I cut the tree a year and a half ago. The back has a texture something like a fine corduroy from where I pulled the bark off. Can I sand the back smooth with out compromising the integrity of the wood, or should I try burnishing it? I'm asking this because I would like to do some decorating on the back.
I also have a shorter bow (hickory) that I've shaped like Reginald Laubin shows in his book. I've got it floor tillered. I'm going to boil the tips when it's warmer out and recuerve them. (learning). I would like to back it with sinew. It came from the same tree as the previous bow. Should I just sand the varnish off or do I have to chemically remove it first? As always, thanks for the help. Al
-
the roughness on the back is probably the trees attempt to start putting down a new layer or wood,,or the actual earlywood,,, was the tree cut spring or early summer,,,,either way wont hury to smooth down because its not doing any work anyway,, I would just lightly sand off varnish,, unless its a very short bow hickory wont need sinew,, unless it is very short,, mike
-
I got a piece of hickory from Pat that was like that. It was a little darker colored like a cambium layer. I scraped it off and had a nice smooth back for the bow.
-
Thanks guys. I'll just get the sandpaper out. The short bow is about 50" long. Just want some experience with sinew. I've only been doing this for a couple years. In my "spare"time.
Thanks again
-
All summer cut hickory I've used looked like that when the bark came off. I wouldn't sand or scrape it. It is as strong as any back is in it's natural state.
-
Thanks Pat
-
I never sand the ripples smooth. Jawge
-
Guess I won't be sanding. Thanks, Guys
-
post a photo,,is what you have got like corse grains of sand on the back,,it is the trees first attempt to put down wood,,there is a two week period each spring that if you cut the tree at this time it will have a rough texture to the wood under the bark,,if I can find a piece I will post a photo
-
don't sand the Back....look at the Character it adds.......... ;D
[attachment deleted by admin]