Primitive Archer

Main Discussion Area => Arrows => Topic started by: stiventiger on November 14, 2010, 02:38:06 am

Title: special design for whistle points
Post by: stiventiger on November 14, 2010, 02:38:06 am
for the 100% copper made for fitting 5/16" vaired shafts and weight 195 Grains each, glue-on type,you should need taper little of the point end of your arrow shafts,quite simple and easy glue on,just in few seconds to fit.
for the iron&steel alloy made for fitting 5/16" vaired shafts and weight 155 Grains each, glue-on type,uniform tube size: no need taper the point end of your arrow shafts,quite simple and easy glue on,just in few seconds to fit.
i change the whistle points head design to let each have the whistle,now in market some the whistle points can't have the whistle sounds.
Title: Re: special design for whistle points
Post by: Aries on November 21, 2010, 08:27:05 pm
i wonder if they have any trouble with clogging if being shot at assorted targets...  card board target.. foam..    ?
Title: Re: special design for whistle points
Post by: oat on November 21, 2010, 10:45:28 pm
It 's take down design so you can take the tip out and clean the holes.
I am wondering if the very tip part going to collapse upon impact on hard target like dead tree.
Title: Re: special design for whistle points
Post by: stiventiger on November 21, 2010, 11:34:25 pm
i wonder if they have any trouble with clogging if being shot at assorted targets...  card board target.. foam..    ?
no problem,we test them a lot of time,see my ebay store describation:http://myworld.ebay.com/stmmrr1968
regards
tiger
Title: Re: special design for whistle points
Post by: stiventiger on November 21, 2010, 11:36:02 pm
It 's take down design so you can take the tip out and clean the holes.
I am wondering if the very tip part going to collapse upon impact on hard target like dead tree.
no problem,the tips are very thicker and stronger enough no collapse even impact rock etc,we test them a lot of time,see my ebay store describation:http://myworld.ebay.com/stmmrr1968
regards
tiger