Primitive Archer
		Main Discussion Area => Arrows => Topic started by: Olanigw (Pekane) on March 30, 2013, 12:43:18 pm
		
			
			- 
				I was finally able to track down some tomato stakes at a local garden store.
The only downside is they're stained green with something.  Not exactly thrilling, but I figured I need something to start with or I'd end up never getting started.
So here ya go!
I burned my fingers, so I whittled  this arrow wrench out of elm for the tight kinks.
(http://i204.photobucket.com/albums/bb208/bipolarskizo/Royce%20Bow/arrow%20making/20130330_105826_zps85590e9c.jpg)
Used the coil burner on my electric stove for heat.  When it warms up a little more and I don't have to keep an eye on my daughter, I will be using a small charcoal oven outside, or a heat gun inside when it's wet.
The end result.  still needs some work, but not bad for 20 minutes.
(http://i204.photobucket.com/albums/bb208/bipolarskizo/Royce%20Bow/arrow%20making/20130330_105130_zpsf894fe88.jpg)
			 
			
			- 
				There you go.  Nothing like working with that cane is there.
			
 
			
			- 
				You can get some pretty decent arrows from garden stakes.
			
 
			
			- 
				If you haven't already, check out Tenbrooks tutorial on Home Depot stakes/arrows above in the sticky section. Looks like you did well with that one! You could probably remove a lot of the dye/paint if it bothers you.
Tracy
			 
			
			- 
				Yes, it was actually Tenbrook's tutorial that infected me with the bug!
Most of the dye rubbed off when I was twirling it between my fingers over the electric coil.  I'm sure I could rub it all off if i tried, but since these are mostly practice I'm not too worried about it.  If they end up being spined right I'll sand and seal and hope I can find them when I miss.
			 
			
			- 
				
Yes, it was actually Tenbrook's tutorial that infected me with the bug!
Most of the dye rubbed off when I was twirling it between my fingers over the electric coil.  I'm sure I could rub it all off if i tried, but since these are mostly practice I'm not too worried about it.  If they end up being spined right I'll sand and seal and hope I can find them when I miss.
Get it wet, man. I have problems when I get those things wet...
If they are dyed the same as mine, then water will help remove the dye. if it is paint, I cannot help you.
			 
			
			- 
				Update:
Slinger, the water did okay and some rubbing alcohol took care of the rest.
I've got the 5 on the left that aren't perfect, but darn close, and the 2 on the right that need a bit more work.
I went back to doing it by hand and wore gloves.  The arrow wrench requires a fine touch to avoid over bending, and I'm a neanderthal.
(http://i204.photobucket.com/albums/bb208/bipolarskizo/Royce%20Bow/arrow%20making/20130408_194954_zps40cfc4b7.jpg)
			 
			
			- 
				Looks like you're ready to fletch and put points on :) 
Tracy
			 
			
			- 
				Looking really good.
			
 
			
			- 
				Looks great.... I do not usually do more than rudimentary straightening.... I am a naturally lazy person....