Primitive Archer
Main Discussion Area => Bows => Topic started by: DC on October 09, 2014, 03:58:45 pm
-
I'm just starting to tiller an OS bow. It has about 2" of reflex. I'm on the long string, but as short as I can make it. I'm maybe getting close to low brace height. I noticed that when I pull the bow slowly and watch a spot about a foot from the handle that I can see the bow slowly bending(moving down) and then when I get to a certain spot it pops back up maybe 1/8 to 1/4" and then continues down as normal. The spot seems to be just after the tips and handle line up. It's acting like an "oilcan" sort of. Is that what it is? It just builds up strain and then pops through?
-
I've used a pulley system that way many times, pulling slowly early on and never seen or ran across that before. Maybe it will work itself out during further tillering? That's a new one on me but I'm sure it's happened before. I have to ask though, the bow is not whip tillered and after the tips bend far enough they pull the reflexed area out near the fade and give you that sudden movement?
Don
-
Just guessing here but I think you are experiencing a sudden change in the string angle or leverage when it starts to break over. I used to notice something similar and eventually started ignoring it.
-
I don't think it's an issue because when it happens it's not even to brace height. It's not tillered enough to think that it's whip tillered. I'm sure it will be gone when I get to brace height(shortly I hope, after my nap :D). I was just curious if others had noticed the same thing. The thought did cross my mind that it might be a warning that a hinge was developing but so far so good.
-
Sounds like a grain issue. Possibly a soft spot.
-
I have noticed that one time. One area of the limb seemed stiff at just past brace height, then bent as it should through the rest of the draw. It did remind me of the oil-can effect, because, compared to the rest of the limb, it seemed to sort of go over-center and then bend.. That bow became a shooter and I don't recall whether the oi-can went away or stayed.
Steve may be right, about the changing string angle.
Jim Davis