Primitive Archer
Main Discussion Area => Primitive Skills => Topic started by: SKÖLDMÖ on December 16, 2016, 10:36:14 am
-
I am making a drinking horn using cow horn. I would like to add some carvings into it, and would drink the best method to carve bone. I do not want to use any form of power drill. Thanks guys!
-
An awl with a sharp point should work fine for it. All you are doing is scratching the surface, wiping on the ink and wiping off the excess leaving the ink in the scratched. For carving a rat tail rasp, files and maybe a sharp blade.
-
For actual carving then a few palm chisels from a good manufacturer are a must. The essential is a v-tool and a nearly flat gouge (a number 3 on the English system); a deep u-gouge is also a really good idea (number 8 )- usually you can only buy palm gouges in sets and these 3 tools are pretty much in all of them but its always worth checking.
-
I have some tools I made up for scrimshawing. One is a nail sanded on a belt sander till it is needle sharp and another is a large leather sewing needle, both mounted in a small wooden handle. I also use an Exacto knife. I sketch what I want on the horn with a pencil and then cut and scrape with the tools. Then rub in real good into the scratches, India ink, or go over the lines with a Sharpie.The sharpie is what I use most and don't have to sand as much to get rid of the excess out of the scratches. And, it lasts for a long time and doesn't fade after it's sealed.
-
I carve horn with files and sandpaper for the most part. If I'm carving knotwork or some similar I use a Dremel tool. Be sure to wear a mask if you do so though.
-
I'll get some pictures of my tools up tomorrow.
-
Here is what I use.
-
Nice scrimshaw Eddie. 8)
-
Thanks, Pat.
-
For scrimshaw I use a awl. I file the awl to a needle point, it makes it easy to scratch the piece of bone that I'm working on at the time. Before I start doing scrimshaw work I get the piece sanded down to the finish I want, then I draw the design with a pencil, then I spray shellac over the piece, after the shellac has dried, then I use the awl to scratch in the design, then I put the India ink on, once I get the design to my liking. I use acetone to wipe off the shellac. This method seems to work good for me.
I've made necklaces out of antler that I done scrimshaw work on.
-
Katie,
Most woodworking shops, such as Woodcraft, carry the individual palm knives and gouges. You also need a carver's glove, or a palm pad.
Have fun!
Hawkdancer(Jerry Mc Connell)
-
Nice work mullet.
-
Way cool Eddie ! Bob
-
Thank you.
-
Many thanks for the thoughts and tips... one more "hobby" I would like to get into...
-
A set of diamond needle files might be helpful for non power work, also. Good luck
Hawkdancer