Primitive Archer
Main Discussion Area => Bows => Topic started by: Jakesnyder on June 23, 2019, 02:08:43 pm
-
Just curious. When does it start affecting the integrity of the wood. Like this picture for example. the back and side of the bow got a little toasty when steaming it. Is this going to affect it at all?
-
That amount, is superficial and won't adversely effect anything.
More to the point how did it happen whilst steaming, I haven't seen wet heat do that? It is pretty common with dry heat, from a heat gun or other source though.
-
That must have been hanging over the steam pot and not protected from the heat coming around the pot. Aluminum foil around those areas helps.
I would round over that back edge to lessen and possible problems from the char.
-
I've had that happen when the heat escapes from the burners around the sides of the pot...That is not a bad burn
Don
+2 PatB
-
I've done that as well, never had an issue from it.
-
That won't happen when you use a wallpaper steamer for your heat source.
-
I heat temper all of my bows - the entire limb looks like that after I'm done!
-
I got distracted one time while steaming a bow, when I came back to look at it the steam pot had boiled dry and my bow limb was on fire from the coleman stove.
-
yes if its on fire, it may be too much )P(
-
Grab a hot dog or marshmellow? (=) >:D (lol)!
Hawkdancer