Primitive Archer
Main Discussion Area => Bows => Topic started by: silent sniper on January 20, 2020, 07:00:14 pm
-
Hey guys,
I wanted to start a discussion on how/if you have any type of break-in period for a new bow that has been tillered but not finished.
Once I get my new bow tillered I will shoot it and unstring it multiple times to watch for any chances in set/limb profile.
After that I will leave it strung for 4 hours followed by an overnight rest. I will than shoot it off and on throughout the next few days as I keep track of the limbs to see if they are taking any set.
I typically will finish with one last 4-5 hr braced secession. If the bow holds up fine than I will go through with finishing It.
Do you guys do it any differently? Are there any break in methods that you believe increase the life of the bow or decrease set?
Thanks
Taylor
-
Not much here. After I am satisfied with the tiller at my draw length I give it 100-150 pulls to full draw on the tree. Then I leave it strung for 6-8 hours. Then shoot it a bit after I get home after it’s been strung all day. Then I’ll unbrace it and check it’s set. Usually the set won’t change much if at all from the final tillering since I exercise the limbs quite a bit during tillering.
-
Nope. Even if you have some program of observing the results, such as set, you're not going to change what happens.
I just add the bow to my rack and shoot it when I want to. Over time, it does what it does.
As for taking it to full draw 100 times in rapid succession, that is punishment my bow would never encounter in normal use.
-
I think shooting is the best break in,..I will leave it strung like hunting,,,
-
As I'm tillering, and I see everything is good once I get to full brace I'll leave the bow braced for an hour(aka sweating). All the while I'm exercising the bow with 20 to 30 pulls after wood removal to the stage I'm at. The farther in the tillering process I go and again if everything is good I'm leave the bow braced longer. As I get to the end of the tillering process and things are still good I'll leave the bow braced for up to about 6 hours. By going this way I have broken in the bow by the time the tillering process is over. Also, any time I brace the bow I will exercise the bow with a series of pulls, increasing the length as I go. I do this EVERY time I brace the bow to shoot as long as I own the bow.
-
I do about like Pat and with good seasoned wood they usually won't change much if any at all. :) I usually tiller one in 2 or 3 sessions with some rest time in between. :)
Pappy
-
Thanks for the replies guys, i appreciate it. It looks like I am doing about the same as everyone else.
Pat, I agree about the warm up draws when stringing up a bow. I also do it and believe it is a good practice.
-
I think its good for the person shooting ,, (-S
-
Pat, I agree about the warm up draws when stringing up a bow. I also do it and believe it is a good practice.
I do a few warm ups too but I'm mostly concerned with the string being seated in the nocks properly. If I screwed up and didn't get the string seated I would just as soon have it come off on a little short pull.