Author Topic: gravel thinning (Read 2123 times)

1442 · « **on:** March 04, 2017, 01:32:57 am »

this piece of gravel is non typical of the gravel I usually work. I think this piece came from farther West.
here's it with the 1-1/2" bopper I'll be hittin it with

1442 · « **Reply #1 on:** March 04, 2017, 01:37:01 am »

first two major flake removals got nice overshots and removed a good amount of mass

1442 · « **Reply #2 on:** March 04, 2017, 01:42:46 am »

first flake on the second side split around a hertzian cone and then the next three attempts failed and made bad stepped terminations

1442 · « **Reply #3 on:** March 04, 2017, 01:53:46 am »

those flake where failing due to the cortex and the stone near it being all cracked and unsolid.
I used the edge created by the termination of that big thick overshot as a platform on the far side and ground the bejeezers out of it until the cortex was rounded over and it worked much better..

1442 · « **Reply #4 on:** March 04, 2017, 02:01:23 am »

I've ran out of time tonight.
It still gots square ends with cortex on one.
one side is pretty flat and the other side has good contours that should allow some more big flakes to be taken.