« previous next »
Pages: [1]

Author Topic: tapering?  (Read 2024 times)

0 Members and 1 Guest are viewing this topic.

Offline recurve shooter

  • Member
  • Posts: 2,325
tapering?
« on: July 22, 2009, 04:55:04 pm »
hi guys. i know that yall are the kings of modification, so i have a question. i have some shafts that are a little to big for the taper tool. is their any way to taper them well without the tool? or do i just need to buy one?
Logged
lets just shoot it

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,496
Re: tapering?
« Reply #1 on: July 23, 2009, 12:47:01 am »
I use my disc/belt sander to make point and nock(if needed) tapers.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline recurve shooter

  • Member
  • Posts: 2,325
Re: tapering?
« Reply #2 on: July 23, 2009, 01:05:14 am »
thanks for the replie. i guess you would just go slow and steady huh?
Logged
lets just shoot it

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,496
Re: tapering?
« Reply #3 on: July 23, 2009, 01:42:33 am »
I have a jig set up with a 5 degree taper for point and 11 degree taper for nock(plastic) adjustment that I clamp to the disc side of the sander.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline recurve shooter

  • Member
  • Posts: 2,325
Re: tapering?
« Reply #4 on: July 23, 2009, 01:58:43 am »
could you explain how to make it, or show pics?
Logged
lets just shoot it
Pages: [1]
« previous next »