« previous next »
Pages: [1]

Author Topic: first homemade broadhead  (Read 3648 times)

0 Members and 1 Guest are viewing this topic.

Offline kevinsmith5

  • Member
  • Posts: 287
first homemade broadhead
« on: January 11, 2013, 10:53:53 pm »
I made this today out of 16 gauge weld steel that picked up at the hardware store. I cut the shapeon my Dremel, heated it with a propane torch and beat in some edge bevels, then heated it, oil quenched it, and sharpened the edges with file and stone. Weighed it on my powder scale at 135 gr (I'd actually figured it out based on square inches of 16 gauge ahead of time at 137.5 gr, so close). Its hatted into the shaft and held in place by hot glue and artificial sinew wraps.
Logged

Offline jeffhalfrack

  • Member
  • Posts: 438
Re: first homemade broadhead
« Reply #1 on: January 11, 2013, 11:03:17 pm »
   Repeat  11 more times  and then go  make  meat!!!  they  look  great!!  JeffW
Logged

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: first homemade broadhead
« Reply #2 on: January 12, 2013, 09:22:07 am »
Good work there.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline osage outlaw

  • Member
  • Posts: 11,951
Re: first homemade broadhead
« Reply #3 on: January 12, 2013, 11:49:29 am »
Looks deadly to me
Logged
I started out with nothin' and I still got most of it left

Offline Adam

  • Member
  • Posts: 912
Re: first homemade broadhead
« Reply #4 on: January 12, 2013, 02:49:38 pm »
That'll get the job done!
Logged
Pages: [1]
« previous next »