« previous next »
Pages: 1 [2]

Author Topic: Another kudo horn nocked bow  (Read 6508 times)

0 Members and 1 Guest are viewing this topic.

Offline PatM

  • Member
  • Posts: 6,737
Re: Another kudo horn nocked bow
« Reply #15 on: December 29, 2013, 08:58:16 pm »
Chichester in Buffalo sells whole Kudu horns. You can see the light tips on the dark horn in this pic.http://www.chichesterinc.com/KuduHorns.htm


Logged

Offline toomanyknots

  • Member
  • Posts: 3,132
Re: Another kudo horn nocked bow
« Reply #16 on: December 29, 2013, 09:54:40 pm »
Quote from: PatM on December 29, 2013, 08:58:16 pm
Chichester in Buffalo sells whole Kudu horns. You can see the light tips on the dark horn in this pic.http://www.chichesterinc.com/KuduHorns.htm

Yeah, a lot of the horn tips have streaks and spots of black in them, those are gonna look cool when turned into nocks.
Logged
"The way of heaven is like the bending of a bow-
 the upper part is pressed down,
 the lower part is raised up,
 the part that has too much is reduced,
 the part that has too little is increased."

- Tao Te Ching, 77, A new translation by Victor H. Mair

Offline DQ

  • Member
  • Posts: 195
Re: Another kudo horn nocked bow
« Reply #17 on: December 29, 2013, 10:01:53 pm »
Jericho.   ;D  Good one!
Logged

Offline turmoiler

  • Member
  • Posts: 105
Re: Another kudo horn nocked bow
« Reply #18 on: January 02, 2014, 09:52:25 am »
Great horns and great bow. I've been wanting to make one like that for some time, can you give us more specs of the bow?
Thanks
Logged

Offline toomanyknots

  • Member
  • Posts: 3,132
Re: Another kudo horn nocked bow
« Reply #19 on: January 02, 2014, 11:30:34 am »
Quote from: turmoiler on January 02, 2014, 09:52:25 am
Great horns and great bow. I've been wanting to make one like that for some time, can you give us more specs of the bow?
Thanks

Thank you. I started with a stave 74" tip to tip, 1" wide 7" in the middle continuously (3 1/2" on either side of center), tapering to 1/2" tips. With this bow, 1/2" was too wide of tips, which I further had to reduce to 3/8" to even get em bending. I had to drill out the horns with a 3/8" bit I have for really thin tipped elbs. The center was also continuously about 13/16" or so thick for 7" in the center (again 3 1/2" on each side of center), tapering to I guess 3/8" tips.
Logged
"The way of heaven is like the bending of a bow-
 the upper part is pressed down,
 the lower part is raised up,
 the part that has too much is reduced,
 the part that has too little is increased."

- Tao Te Ching, 77, A new translation by Victor H. Mair
Pages: 1 [2]
« previous next »