« previous next »
Pages: [1]

Author Topic: Glue for horn?  (Read 2303 times)

0 Members and 1 Guest are viewing this topic.

Offline Mafort

  • Member
  • Posts: 417
Glue for horn?
« on: December 28, 2018, 09:59:04 pm »
What kind of glue can I use to keep horn inserts from popping out? I remove the clamp and the horn literally falls out. I was using Titebond 3
Logged

Offline EdwardS

  • Member
  • Posts: 229
Re: Glue for horn?
« Reply #1 on: December 28, 2018, 10:49:54 pm »
I used hide glue, personally.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,489
Re: Glue for horn?
« Reply #2 on: December 28, 2018, 10:52:39 pm »
I've used TBIII and wrapped with rubber band until the glue cures...tomorrow.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Strelets

  • Member
  • Posts: 93
Re: Glue for horn?
« Reply #3 on: December 30, 2018, 11:26:00 am »
I use cyanoacrylate (superglue). Not authentically primitive, but it bonds in seconds and they never fall out.
Logged

Offline BowEd

  • Member
  • Posts: 9,390
  • BowEd
Re: Glue for horn?
« Reply #4 on: December 30, 2018, 04:34:27 pm »
Smooth on.
Logged
BowEd
You got to stand for something or you'll fall for anything.
Ed

Offline Scyth

  • Member
  • Posts: 74
Re: Glue for horn?
« Reply #5 on: December 30, 2018, 07:50:27 pm »

1.) I scuff it up with 120 grit sandpaper . . .

2.) I wipe it off with Methananol . . .

4.) I use hide glue or Devcon 5 minute epoxy . . .


regards,

Scyth
Logged
"Retirement is not a word in the dictionary of craftsmen
and I will carry on my work a long as I can . . . "

- Yang Fuxi
Pages: [1]
« previous next »