Taper for glue on points

[Allyn T]

How do you know how much to taper to fit on the points? I can't tell if there is space inside or not

[Pat B]

It approximately a 5 degree taper. How are you tapering the arrows?

[Allyn T]

I used a belt sander. I tapered steeper than that I think. I tried to fit the arrow all the way in as far as it would go, do you normally not do that?

[Hawkdancer]

I use the pencil sharpener taper cutter(3 Rivers, Lancaster, et al). You do want as much wood to metal contact as possible, and both glue and metal hot.  IMO!
Hawkdancer

[Pat B]

You do need a good fit to keep the arrow/point true or the arrow won't fly right.

[Allyn T]

I had already glued them before I posted but was afraid I didn't do it right. I shot 3 arrows into my basement wall tonight and all three points stayed on the tips so I guess I did ok. The arrows themselves didn't fare so well...

[Yooper Bowyer]

I use a bearpaw taper tool, pencil sharpener type.  They have replaceable blades, which is a big plus over the 3Rivers Archery type.

[Mesophilic]

I use my belt sander as it's pretty fast.  I can usually free hand with excellent results.  If I'm on an off day, I clamp a piece of wood to the tool rest at an angle to get it right.  Same thing if I'm doing glue on nocks.

I glue on with epoxy, the gap filling properties are a bonus.  My process for gluing on is a bit of a hassle but I never lose a tip.

[Allyn T]

Taper tool would have been easier for sure but I didn't know I'd be gluing on points. I like the idea of a jig for the belt sander