Main Discussion Area > Arrows
some BIG sawblades...arrowheads and knife blades
crooketarrow:
Now thats a band saw blade. BILL's right grind the back part of your nocks so they set in below the blade. NICE
George Tsoukalas:
That's some good work! Jawge
Mohammad Javad Shoaee:
That's a great arrowhead.how did you cut them?
half eye:
Hey Fellas,
Forgot that part.....I did not cut them out.....by having the big blades sheared to 1-1/8 wide I just draw a line in the middle and then go corner to corner on both halves.....and use a shear press to bang them out. I dont have a press but I have some friends at the local welding shop, and they do.
The picture with the blank and the 4 arrowheads in it is how I lay 'em out to shear them. I used a bench grinder to set the intial edges, then filed then to dress 'em up. and then went to some 800 wet/dry paper glued to a steel block to get them "scary".
rich
beetlebailey1977:
Rich,
Those look good on the arrows. They look like killers for sure. I would probably take that back edge down behind the wrap also. It would help with penetration. I can't wait to try some of them.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version