Main Discussion Area > Around the Campfire

New bit

<< < (2/3) > >>

cracker:
That claw is pretty impressive what kind of a torque load does it put on you're equipment as compared to the roller bit?Ron

skyarrow:

--- Quote from: cracker on March 18, 2011, 05:59:52 pm ---That claw is pretty impressive what kind of a torque load does it put on you're equipment as compared to the roller bit?Ron

--- End quote ---
I'm not sure we don't have any gauges to tell the difference in torque but I can say we had to ride the break It was cutting so fast

mullet:
 But they are so expensive. I've got roller bits I've been using for the last 20 years. I don't cut the big holes enough to justify the cost. But, I can see where they would be easy to rebuild.

skyarrow:

--- Quote from: mullet on March 18, 2011, 09:26:11 pm --- But they are so expensive. I've got roller bits I've been using for the last 20 years. I don't cut the big holes enough to justify the cost. But, I can see where they would be easy to rebuild.

--- End quote ---
This opener cost around 850$ that's not that bad itl pay for it's self in one job

mullet:
 Can you email me the info where you are getting them. I'd like to try one in one of these Gyp stacks like what I'm drilling in Pasadena.

Navigation

[0] Message Index

[#] Next page

[*] Previous page