« previous next »
Pages: [1] 2

Author Topic: Splinter repair help!!  (Read 7268 times)

0 Members and 1 Guest are viewing this topic.

Offline DraggingCanoe

  • Member
  • Posts: 27
Splinter repair help!!
« on: January 19, 2012, 02:33:57 pm »
I have an Osage longbow that's backed with bamboo and the bamboo backing is starting to lift a small splinter right at the edge of it. Should I put super glue in it or what? It's my first and only bow and I REALLY don't want to lose it so any help would be greatly appreciated.
Logged

Offline bubby

  • Member
  • Posts: 11,054
Re: Splinter repair help!!
« Reply #1 on: January 19, 2012, 03:00:52 pm »
it's hard to see in the pic but i've super glued and wrapped before, Bub
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,496
Re: Splinter repair help!!
« Reply #2 on: January 19, 2012, 03:11:09 pm »
I'd put super glue in it and wrap with a rubber band until the glue dries, remove the rubber band, sand that area smooth and add a permanent wrap of sinew or strong thin thread like silk. Once wrapped, set the wrap in super glue and add a your finish over that.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline DraggingCanoe

  • Member
  • Posts: 27
Re: Splinter repair help!!
« Reply #3 on: January 19, 2012, 03:12:25 pm »
sounds good, will artificial sinew work?
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,496
Re: Splinter repair help!!
« Reply #4 on: January 19, 2012, 03:44:07 pm »
It will but it is pretty stretchy so won't give as good of support as silk or linen thread
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: Splinter repair help!!
« Reply #5 on: January 19, 2012, 04:22:11 pm »
Artificial stuff tends to not stick to the bow either, its covered in wax. The glue you use wont soak in well either. Use silk thread as Pat suggested, or buy one leg sinew dirt cheap and make your own easily. I like the real stuff for wraps.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline Parnell

  • Member
  • Posts: 5,551
Re: Splinter repair help!!
« Reply #6 on: January 19, 2012, 04:24:32 pm »
Spiderwire as a wrap? 
Natural sinew probably looks  better though.
Logged
1’—>1’

Offline JW_Halverson

  • Member
  • Posts: 11,853
Re: Splinter repair help!!
« Reply #7 on: January 19, 2012, 08:21:54 pm »
Plain old cotton sewing thread wrapped in a single layer provides quite a bit of support to a bow back once you lock it down with a wetting of superglue.    Just start winding the thread tightly, slide each wrap up tight against the wrap before so there is no gap.  You can also pick two colors that contrast just to make it decorative.  Maybe even duplicate the wrap on the other limb for visual balance.
Logged
Guns have triggers. Bicycles have wheels. Trees and bows have wooden limbs.

Offline DraggingCanoe

  • Member
  • Posts: 27
Re: Splinter repair help!!
« Reply #8 on: January 19, 2012, 08:24:43 pm »
I was actually just about to ask if cotton thread would work because I've got to work with what I have already ($$$). What about supergluing the splinter down and then wrapping it with a strip of rawhide sewed up the belly?
Logged

Offline DraggingCanoe

  • Member
  • Posts: 27
Re: Splinter repair help!!
« Reply #9 on: January 19, 2012, 08:29:58 pm »
should I get a picture of the bow at full draw with an arrow to where the splinter is to show where it is in relation with the working parts of the limb, or does it matter?
Logged

Offline Bevan R.

  • Member
  • Posts: 1,691
Re: Splinter repair help!!
« Reply #10 on: January 19, 2012, 08:37:33 pm »
You could try wrapping with rawhide if it was a long strip, like you would a handle. drying rawhide would probably pull out any stitching.
I have wrapped with cotton soaked with TBII. In the working part of the limb.

Bevan
Logged
Bowmakers are a little bent, but knappers are just plain flaky.

Offline soy

  • Member
  • Posts: 2,897
  • pm106221
Re: Splinter repair help!!
« Reply #11 on: January 19, 2012, 11:14:00 pm »
I have had success with Kevlar thread and super glue
Logged
Is this bow making a sickness? or the cure...

Offline DraggingCanoe

  • Member
  • Posts: 27
Re: Splinter repair help!!
« Reply #12 on: January 20, 2012, 04:51:06 am »
Thanks for the help guys. I'll let you know how it goes.
Logged

Offline Pappy

  • Global Moderator
  • Member
  • Posts: 31,767
  • if you have to ask you wouldn't understand ,Tenn.
Re: Splinter repair help!!
« Reply #13 on: January 20, 2012, 08:56:21 am »
I wouldn pull it any more until the repair has been made,it can and probably
will get a LOT worse if you keep pulling it.  :)
   Pappy
« Last Edit: January 20, 2012, 10:43:39 am by Pappy »
Logged
Clarksville,Tennessee
TwinOaks Bowhunters
Life is Good

Offline Dazv

  • Member
  • Posts: 472
Re: Splinter repair help!!
« Reply #14 on: January 20, 2012, 10:37:22 am »
i agree with pappy don't bent the bow untill you have fixed the splinter.
Logged
Pages: [1] 2
« previous next »