Main Discussion Area > HowTo's and Build-a-longs

Recurve jig build-a-long

<< < (2/5) > >>

VicNova:
Next I draw in a lip at the bottom so that a bow tip can be held in place with a clamp.

VicNova:
Next I securce the whole thing to a solid surface. Since I don't have a vise , post and bar clamps will have to do.

Then I start cutting away all the bulk wood and get as close to the outline as possible. A tiger saw really works great for this step.

VicNova:
After I have the rough cut outline I take a nice big rasp and smooth out the curve as best as possible. It doesn't have to be super fantastic or anything, a few little dips or gouges has never been a problem when using the jig.

VicNova:
After that I cut out the lip on the bottom of the jig.

Once that is complete the jig should look roughly like the last picture.

VicNova:
After that is finished I gather all the tools below.

Then I spread wood glue on both surfaces.

After that I line up the pieces together as best I can and press them firmly together.

Navigation

[0] Message Index

[#] Next page

[*] Previous page