« previous next »
Pages: [1]

Author Topic: What is a good length?  (Read 1392 times)

0 Members and 1 Guest are viewing this topic.

Offline Prarie Bowyer

  • Member
  • Posts: 1,599
What is a good length?
« on: April 01, 2013, 02:17:15 pm »
I have a 28" draw... I've been making my arrows a bit longer than what you would traditionaly buy in carbon.  But I'm making a new set of footed arrows and I'm looking at my materials and wondering if they will be long enough.

I'm at 30" on them. They feel short... but that could just be because i'm dropping from a longer shaft.

I'm footing an 8" section of wallnut onto a 26" piece of Linden and tapering the shafts at the nock end. 

Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,511
Re: What is a good length?
« Reply #1 on: April 01, 2013, 04:15:41 pm »
I shoot 30" arrows for my 26" draw.
  You have to remember store bought arrows are spined for 28" with a 125 gr point and for each inch over 28" you have to subtract 5# of spine weight(add spine weight for less than 28"). Any point heavier than 125gr will reduce the spine by 5# per additional 15gr or so(lighter increases spine weight). Depending on the weight of the footings that could change spine also.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Roy

  • Member
  • Posts: 1,079
Re: What is a good length?
« Reply #2 on: April 01, 2013, 10:21:44 pm »
Right on Pat.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,511
Re: What is a good length?
« Reply #3 on: April 02, 2013, 12:17:50 am »
I know it all Roy if I could only practice what I preach.  ???
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Prarie Bowyer

  • Member
  • Posts: 1,599
Re: What is a good length?
« Reply #4 on: April 02, 2013, 08:41:02 pm »
I thought it felt a tad short.
Logged
Pages: [1]
« previous next »