Main Discussion Area > HowTo's and Build-a-longs
spine tester build along
richpierce:
^Thanks, just need clarification- what part of the picture is 5.25" tall? The graphic part alone? What part is 7" wide? The graphic part plus the legends?
DanaM:
rich I think just the graphic part is 5.25" by 7"
waterlogged:
Rich - To make sure the graphic is accurate, open up the link of your choice, then right click on it and select save as. Save the image into a folder of your choice. Then open a new MS word document, select insert off the file menu, then go down to picture, then select from file. Find the meter that you saved, and insert it. Expand the total area by draging the lines between the grey and the white areas on the top ruler so that it's 7 inches wide (and roughly centered so your printer can get to it). Then click on the image and drag the tabs on the image to make it 7 inches wide and 5 inches. Print, cut out and enjoy :)
Sorry rob if that's a little simplistic, not trying to insult your computer savvyiness, just figure someone will need it.
carpenter374:
I printed the pic but just one question. the black line is supposed to represent 70-75 and the needle moves upward with more weight. aren't the colors backwards?
waterlogged:
Carpenter- the black 70-75 is that black wedge just below the purple wedge. The colors are right, what's being measured is how much the weight bends the arrow. When the same amount of weight bends the arrow more, the arrow is for a lighter bow.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version