Information and Resources > Trading Post

Looking for a feather burner

<< < (4/5) > >>

lebhuntfish:
Check out bubbies post in this thread.  Pretty much what I made. I think I used this plan. 

http://www.primitivearcher.com/smf/index.php?topic=28966.0

Patrick

osage outlaw:
I put my charger on 6 volts when I used a homemade one.  I used a set of jumper cables and my car battery before I got a charger.  I just unhook the clamp after each arrow.

wizardgoat:
Sorry guys I missed a lot of this. I think I figured out a way to use my wood burner. Was going to use a burner pen we never use, and solder on a wire. Fix it all to a jig, my wood burner set has a dial to turn up the heat and down, and it does get red hot so I figure it should work?

lebhuntfish:
Post some pictures when you're done Ryan.
Sounds like it will work to me!

Patrick

le0n:

--- Quote from: wizardgoat on July 28, 2016, 01:38:16 pm ---Was going to use a burner pen we never use, and solder on a wire. ...red hot so I figure it should work?

--- End quote ---

if you're removing the actual heating element of the pen and replacing it with the burner wire, then yes it will work.

i'd question if soldering directly to the element would give even heat throughout the burner wire though. also, if the wood burner element gets red hot, it could melt the solder points if turned up too high.

Navigation

[0] Message Index

[#] Next page

[*] Previous page