Main Discussion Area > Arrows

will loon make an arrow?

<< < (2/3) > >>

Aaron H:
Those are digital calipers Ed, looking good Loon

BowEd:
OK...cool.That'll do it then.
Loon...You should make a graph now to show what is what.Tape it to the spiner.You can refer to it in a flash.
Also you better make sure that calipers is in the same place every time you use it.

loon:
that would be faster, but I can zero the caliper when it touches the arrow without a weight. Should probably lube it or something, it's not very smooth so I have to mess with it so it doesn't press on the arrow more than the weight does


--- Quote from: TSA on November 15, 2017, 08:38:07 am ---looks awesome!!
looks to be about a #50 shaft??? ;D
offer a prize ( accolades and fame) as to who can guess the spine ;D

--- End quote ---
Yup, measured 54#

next step is to figure out how I'll heat straighten bamboo.. maybe I could make something like Danzn Bar's tool but with aluminum foil instead of a thick aluminum sheet haha. Or I could try to keep doing it by hand  :-\ I'm not very good at it

DC:
It takes practice, but you've heard that before ;)

TSA:
cool- just looked like a #50 bend!  :)

nice job- and some good tips there!

Navigation

[0] Message Index

[#] Next page

[*] Previous page