Main Discussion Area > HowTo's and Build-a-longs
How I repair self nocks
DC:
I'm not sure how this happened but one side of the nock broke.
DC:
I sanded down the sides on my belt sander so the bottom of the nock was still original
DC:
Then I sanded two pieces of Purple Heart(to match the footing) so the sides of the nock were parallel. I could have done a better job but I was thinking of the how-to rather than the work at hand.
DC:
Glued one side on using thick CA
DC:
Then the other. Gluing them one at a time is less fiddly.
Navigation
[0] Message Index
[#] Next page
Go to full version