Main Discussion Area > At the Forge

Small Adze

(1/2) > >>

Handforged:
Had a request for a small adze for working down staves. This one is 1050 steel with a 1084 cutting edge forge welded in the bit for a harder sharper cutting edge. 1.5" cutting edge with a 2.25" throat. This one was made with a rectangle eye that should accept a standard hammer type handle. This will give a good reach for the smaller head. Turned out well I think. Enjoy!

Mr. Woolery:
That is a really sweet tool!

Patrick

Handforged:
Thanks! I finished it up with a forge black finish and soaked it in oil for a few hours. Ready to remove some wood now.

Trapper Rob:
You do really nice work

Aaron H:
That thing is too cool.  You do great work

Navigation

[0] Message Index

[#] Next page