Main Discussion Area > Bows

Cut to much out at fade.

(1/2) > >>

Selfbowman:
I’m building a 45# bow.70” ntn, 9” handle, 1-3/4 wide at fades, 1/1/2” mid limb 5/16 wide tip. 31” draw. Pretty sure I over cut my fades.any suggestions?

Selfbowman:
Would this work assuming that would be thick enough for 45# bow?

Hamish:
You should be fine with 1&3/4" wide osage limbs. A bow like that usually ends up with pretty shallow limbs.

You want to take it slow, and get the limbs bending properly, before doing any drastic stock removal, near the fades to avoid any hinges.

bentstick54:
Arvin, I just do a 4” rectanglular handle, no shelf, and 2-1/2” or 3” fades. But your penciled in fade looks very close to what I do on all my bows. I’ve used that up to 57# at 28” bows from 63” to 68” with no problems. I think your in good shape.
Here’s the snakey bow that I haven’t finished yet.

superdav95:
Same here.  I think you still have some room.  Not much but still a 45-50lb bow in there. 

Navigation

[0] Message Index

[#] Next page