Main Discussion Area > Bows
Hi tech redneck flight bow.
Selfbowman:
Again has anyone out there tillered a bow by profile and force draw curve before!!!! I think they go hand in hand. That’s going to be my approach on this because the thickness is not working.
superdav95:
I beg your right about the heat changing things. It may settle in pretty close when you finish up tiller after all said and done in the end but for now I’m betting it’s off because of that. It’s pretty darn close for unstrung profile though! Nicely done.
Selfbowman:
Ok pattern for tiller done.
mmattockx:
--- Quote from: Selfbowman on October 21, 2024, 02:21:22 pm ---That’s going to be my approach on this because the thickness is not working.
--- End quote ---
What is not working on the thickness?
Mark
Selfbowman:
Getting close. The numbers are hitting real close. Been to 18” . Profiles are almost dead on. The last seven inches will tell the tail.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version