Main Discussion Area > Bows
Arvin and me
willie:
--- Quote from: bjrogg on January 28, 2025, 07:26:46 pm ---
The back is very flat.
The belly was almost what I think you would call trapped?
When I tillered I removed the peak of the trap.
If I remember correctly there is still a trapped edge over most of the working limb.
Bjrogg
--- End quote ---
did you flatten the back or were the rings that way when you got it?
bjrogg:
The back was naturally flat. It already had the ring chased and sealed. I didn’t touch it
Bjrogg
bjrogg:
Willie I posted width at fade wrong previously. I corrected it now. I’m going to get you some better measurements
Out of fade was 1.595”
Working on it now
Bjrogg
bjrogg:
Willie I must have been holding the dummy end of the tape before. I didn’t think it was 2” wide
I used calipers now. I measured at thickness and width at fade and then @ 4,8,12,16,20,24”
I did top and bottom limb
Bjrogg
Ps hope you can read my children scratching
bjrogg:
I missed a line first picture i fixed it
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version