Main Discussion Area > Bows

64” recurve computer design

<< < (3/6) > >>

Wallski:
I like this design, and I would like to try it.    How thick is the smallest part of your raiser, where you heated it for the bend?


Thanks Steve

Pappy:
Looking good, nothing much smoother than a R/D design. Not sure on them being the fastest but are almost always sweet shooters.  :)
 Pappy

Selfbowman:
At the bottom of the 1/4 moon it’s about to 3/4” thick. That is enough to dry heat the deflex in. Also you can take the propeller out if you have any. Matching the piece back in so you have a tight glue joint  is a pain but worth the out come. Forth heat correction. Getting close. I have the limbs close on width and thickness. Sanding block from here on out.

Selfbowman:
Got her lined up pretty good.

Badger:
   Because of the high early draw weight, these bows are very easy to come in light on. The bow looks great.

Navigation

[0] Message Index

[#] Next page

[*] Previous page